Vivitek Projector D732MX User Manual

Copyright  
This publication, including all photographs, illustrations and software, is protected under international copy-  
right laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be  
reproduced without written consent of the author.  
© Copyright January, 2007  
Disclaimer  
The information in this document is subject to change without notice. The manufacturer makes no repre-  
sentations or warranties with respect to the contents hereof and specifically disclaims any implied  
warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to  
revise this publication and to make changes from time to time in the content hereof without obligation of  
the manufacturer to notify any person of such revision or changes.  
Trademark Recognition  
Kensington is a U.S. registered trademark of ACCO Brand Corporation with issued registrations and pend-  
ing applications in other countries throughout the world.  
All other product names used in this manual are the properties of their respective owners and are ac-  
knowledged.  
i —  
 
Preface  
Power Safety  
Only use the supplied power cord.  
Do not place anything on the power cord. Place the power cord where it will not be in the way of  
foot traffic.  
Remove the batteries from the remote control when storing or not in use for a prolonged period.  
Replacing the Lamp  
Replacing the lamp can be hazardous if done incorrectly. Refer to “Replacing the Projection Lamp” on  
page 30 for clear and safe instructions for this procedure. Before replacing the lamp:  
Unplug the power cord.  
Allow the lamp to cool for about one hour.  
Cleaning the Projector  
Unplug the power cord before cleaning. Refer to “Cleaning the Projector” on page 33.  
Allow the lamp to cool for about one hour.  
Regulatory Warnings  
Before installing and using the projector, read the regulatory notices in the “Regulatory Compliance” sec-  
tion on page 43.  
iii –  
 
DLP Projector—User’s Manual  
Main Features  
Lightweight unit, easy to pack away and transport  
Compatible with all major video standards including NTSC, PAL, and SECAM  
A high brightness rating allows for presentations in daylight or in lit rooms  
Supports resolutions up to SXGA at 16.7 million colors to deliver crisp, clear images  
Flexible setup allows for front and rear projections  
Line-of-vision projections remain square, with advanced keystone correction for angled  
projections  
Input source automatically detected  
About this manual  
This manual is intended for end users and describes how to install and operate the DLP projector. Wher-  
ever possible, relevant information—such as an illustration and its description—has been kept on one  
page. This printer-friendly format is both for your convenience and to help save paper, thereby protecting  
the environment. It is suggested that you only print sections that are relevant to your needs.  
iv —  
 
Preface  
Table of contents  
SPECIFICATIONS...............................................................................................ERROR! BOOKMARK NOT DEFINED.  
SPECIFICATIONS........................................................................................................... ERROR! BOOKMARK NOT DEFINED.  
v –